Tags
Related Posts
Share This
Cooling Tips for Your Data Center
Are you searching for a way to maximize your data center performance and uptime while minimizing the operational costs? If so, you should think of how you can maximize cooling ability. If your data center design is not set up for sufficient cooling, then it can put a significant strain on the entire infrastructure, which will reduce the operational efficiency, while leading to serious disruptions in day to day operations.
By following a few simple guidelines, you can significantly increase the total efficiency of the data center and help to reduce operational costs.
The top tips you can implement for cooling your data center are highlighted here.
Cold versus Hot Air
The primary rule related to the cooling of your data center is keeping the cold and the hot airflows from becoming mixed. When you place your servers in parallel rows that are arranged in a back-to-back or front-to-front arrangement, you will create hot aisles and cold aisles, which will keep the air from getting mixed. Containment centers for modern data centers can provide the isolating factors necessary for cold and hot airflows in the space.
Airflow Bypass
No matter if it is between, below, above or inside server racks, an air bypass will help to reduce the total effectiveness of your cooling and containment systems. Instead, use a blanking panel inside the racks, and air barrier between, below and above the racks, as well as air dam foam that is fire safe for sealing any gaps that will allow the hot air to make its way into the various cold aisles.
Placement of the Floor Tiles
When it comes to perforated floor tiles you need to be sure you use the proper number and that you locate them in the proper places in order to achieve proper cold airflow in the areas where it is needed. Be sure that you revisit the placement of the floor tiles, since the IT configuration will change as time passes. You should be sure not to install any floor gates very close to your CRACs.
The Location of Cool Ducts
You should match the cooling ducts that are overhead to your rack configuration. Ensure that the ducts also are cleaned frequently and that the vents do not become blocked.
Turn Off the Lights
While this may seem a bit obvious, it is a factor that is often overlooked. When you are not occupying the server room, then you should turn off the lights. A good way for you to manage this is with motion activated light switches. This can reduce the total heat load in the data center by as much as three percent and lower the entire room temperature by as much as two degrees.
If you are looking for a new data center design, visit the site raritandcim.com for more information.
Recent Comments